A precision engineered Standard Length Brass Pinion Support Pin which fits in the driveshaft of all Daiwa 7HT models. It has a working length of approximately 12mm which is ideal for this purpose. This part adds support to the pinion and gears of these reels increasing the strength of the drive and reducing wear; it is vital if if you intend fitting a larger, custom power handle to your reel.

The pin is simple to fit. Simply remove the handle cap screw, plastic handle cap, circlip and thrust washer. Oil the pin, slide it into the tunnel in the drive shaft and then reassemble. Full instructions are included.

Manufacturers
We Accept