The standard "crutch type" butt cap has been around for years and is a cheap and inexpensive way to finish off and protect the butt of your rod. They also have the advantage of having a stainless steel penny washer inside which not only stops the bottom of the rod digging into the rubber over time but will support the butt should the end be trodden on - I've seen more than one rod saved by these butt caps over the years.

Although these caps have an inside diameter of 24mm they will stretch out a bit to maybe 28mm if needs be - heat them up in hot water for a few minutes prior to fitting if you need to get a stretch fit.

Length: 35mm
Bore Size: 24mm

Manufacturers
We Accept