A stainless steel 8x10x0.5mm spacer shim for use on reels with an 8mm drive shaft. Very useful for…
- Model
- dnshim10-05
A stainless steel 8x12x0.1mm spacer shim for use on reels with an 8mm drive shaft. Very useful for…
- Model
- dshim01
A stainless steel 8x12x0.2mm spacer shim for use on reels with an 8mm drive shaft. Very useful for…
- Model
- dshim02
A stainless steel 8x11x1mm spacer shim for use on reels with an 8mm drive shaft. Very useful for…
- Model
- dnshim11-1
A stainless steel 8x10x1mm spacer shim for use on reels with an 8mm drive shaft. Very useful for…
- Model
- dnshim10-1
Replacement Brake Adjuster Screw to fit Daiwa 7HT Mag , replaces Daiwa part number 63517709.
This A4 stainless…
- Model
- 63517709
A replacement Shimano TSM II Strike Ball, the small stainless steel ball bearing that fits into the drag adjuster…
- Model
- TGT0152
Replacement Drag Seal O-ring to fit various Daiwa Sealine X models.
This part is situated at the top…
- Model
- F65-7801
Replacement Side Plate Locating Pin (Pin A) to fit various Daiwa Saltist models.
This part fits in…
- Model
- G21-1701
This set of three nylon washers are a simple way to prevent damage to the finish of your Penn…
- Model
- 1188649
These nylon washers are a simple way to prevent damage to the finish of your Penn Fathom side plates…
- Model
- 1188649
Genuine Daiwa Handle Plate Screw to fit the Daiwa Millionaire 7HT Magnafuge.
Daiwa part number 353-8302.
Please check your schematic…
- Model
- 353-8302
Clutch (freespool) Spring to fit Daiwa SL20SH, SL30SH and other Daiwa models.
This part is fitted to the…
- Model
- F02-0301
Genuine Left Sideplate Screw to fit the Daiwa Millionaire 7HT Mag.
Daiwa part number E31-7401.
PER SCREW
Please check your schematic…
- Model
- E31-7401
Genuine Daiwa Handle Nut to fit the Daiwa SL20SH, SL30SH and the 20/30 SHV models.
Daiwa part number B86-2101/B86-2102.
Please…
- Model
- B86-2101/2102
Anti-reverse pawl spring to fit Daiwa SL20SH and SL30SH.
This part is fitted to the reels anti-reverse pawl.
Daiwa…
- Model
- E31-6502
A pair of stainless steel allen head Handle Locking Plate Screws to fit most of the smaller and medium…
- Model
- avethks
Genuine Daiwa Handle Nut Plate to fit the Daiwa Millionaire 7HT Magnafuge.
Daiwa part number 040-3201.
Please check your schematic…
- Model
- 040-3201
A Handle Thrust Washer to fit the ABU 5000 and 6000 series and the Daiwa 7HT Original, Turbo and…
- Model
- 150-9001
Replacement Penn 525MAG Pinion Bearing - 440 Stainless steel.
Replaces the pinion roller bearing that is pressed into the cage…
- Model
- EB13
Displaying 1 to 20 (of 82 products)